Research Topic

Reactive

17 Publications Matching this Keyword

Impact Factor
7.883
Reactive

17 Matching Papers


All Categories
Publish Your Paper

Submit your research manuscript for fast peer review and publication.

Submit Paper

Papers tagged with "Reactive"

Showing page 1 of 2
Vol 11, Issue 11 (November 2025) Electrical Engineering

Enhancing Reactive Power Compensation Through Shunt Reactive Elements For Improved Voltage Stability

This Paper Presents The In Modern Electrical Power Systems, The Efficient Management Of Reactive Power Has Become Increasingly Critical For Ensuring System Reliability, Voltage Stability, And Energy Efficiency. Reactive Power, Though Essent...

Shinde H. Rajendra
Vol 9, Issue 5 (May 2023) EE

A SIMULATION OF A STATCOM-CONTROL FOR GRID CONNECTED WIND ENERGY SYSTEM FOR IMPROVING RELIABILITY OF POWER

Injection Of The Wind Power Into An Electric Grid Affects The Strength Exceptional. The Overall Performance Of The Wind Turbine And Thereby Electricity Nice Are Determined On The Basis Of Measurements And The Norms Observed According To The...

Gourav Kumar, Dr. Mithilesh Singh, Gokul Dewangan
Vol 9, Issue 4 (April 2023) Power System

REACTIVE POWER COMPENSATION USING INDUCTION MOTOR DRIVEN BY FOUR SWITCH CONVERTER

During The Past Two Decades, The Rise In Electrical Energy Demand Has Presented Higher Necessity From The Power Industry. More Power Plants, Substations, And Transmission Lines Need To Be Built. However, The Most Commonly Used Devices In Pr...

M.Manjula, V.Jothinivetha, R. Keerthana, A.Dharanya
Vol 7, Issue 12 (December 2021) Electrical Engineering

Improvement Of Voltage Magnitude And Phase Angle In Transmission Line Using STATCOM As Compensator

A STATCOM Is Employed To Improve The Power Factor At The Load End In This Article. The Power Factor Of The Loads Connected To The Network Determines The Degree Of Power Use. Because Most Of The Loads In The Distribution Line Are Inductive,...

Mr.Arvind Sudhakar Hirole, Prof.Yogesh P.Sushir, Prof.Jitendra R. Hanumant, Prof. Deepesh Bhati
Vol 7, Issue 4 (April 2021) Computer Engineering

load flow analysis of ieee 30 bus system

Load Flow Analysis Is An Important Tool Used By Engineers To Determine The Best Operation For The Power System And Exchange The Power Between Two Utility Companies, To Have An Efficient Method Of Load Flow Power System, We Have To Determine...

Ritesh Raut, Saquib Khan, Kuldeep Lakhe
Vol 7, Issue 4 (April 2021) Electrical & Electronic Engineering

POWER QUALITY IMPROVEMENT IN TRANSMISSION LINE

This Paper Presents D-Q Synchronous Reference Frame (SRF) Current Control Technique To Create The Necessary Reference Current For 3-stage 4-wire Shunt Crossover Dynamic Force Channel (SHAPF) To Take Care Of Sounds Issue In Power Framework O...

M.Jaisankar, M.Mahendren
Vol 6, Issue 10 (October 2020) Civil Engineering (concrete Technology)

STUDY ON REACTIVE POWDER OF CONCRETE BY PARTIAL REPLACEMENT OF CEMENT IN ADDITION WITH STEEL FIBER”.

The Main Objective Of This Investigate Is To Utilize The Reactive Powder In Normal Concrete To Obtain Strength By Fully Replacement Of Natural Sand To Artificial Sand To Reducing The Lack Over Excavation Of Sand Pose A Serious Environmenta...

Shankar Godase, Tapkire P.P
Vol 5, Issue 1 (January 2019) EEE

CONTROL OF ENHANCED VIRTUAL SYNCHRONOUS GENERATOR FOR PARALLEL INVERTERS IN MICROGRIDS

Virtual Synchronous Generator (VSG) Control Is A Promising Communication-less Control Method In A Microgrid For Its Inertia Support Feature. However, Active Power Oscillation And Improper Transient Active Power Sharing Are Observed When Bas...

G.Venkatesh , S.Venkat Rao
Vol 4, Issue 12 (December 2018) Electrical Engineering

TO REDUCE HARMONICS AND IMPROVE THE REACTIVE POWER BY THREE PHASE ACTIVE FILTER

This Paper Deals With A Parallel 3-phase Active Filter To Eliminate Harmonics And To Compensate The Reactive Power Of The Non-linear Loads. A 3-phase Voltage Source Inverter Bridge With A Dc Bus Capacitor Is Used As An Active Filter (AF). A...

Hemant Kumar, Er. Rahul Srivastava
Vol 4, Issue 9 (September 2018) NA

A NOVEL APPROACH FOR HARMONICS ELIMINATION BY PWM TECHNIQUE USING SHUNT ACTIVE FILTER IN MATLAB

This Paper Deals With A Parallel 3-phase Active Filter To Eliminate Harmonics And To Compensate The Reactive Power Of The Non-linear Loads. A 3-phase Voltage Source Inverter Bridge With A Dc Bus Capacitor Is Used As An Active Filter (AF). A...

Priyanaka Yadav, R.K.Vyas
Vol 4, Issue 8 (August 2018) Computer Science & Engineering

Improving Network Performance by Minimizing Congestion in MANET

Congestion Is The Major Issue In Mobile Ad Hoc Network. Which Is Responsible For The Packet Loss In The Network And The Packets Are Not Reached To The Destination. Mainly Bypass Route Is Selected For Transmission Of Data If Congestion Occur...

Anjali Rajput, U.Datta
Vol 4, Issue 4 (April 2018) Electrical And Electronics Engineering

Shunt Capacitor Placement Techniques To Improve The Stability of Power Systems

With Increasing Non-linear Loads Harmonic Currents Are Created In The Power System And Distorted All Of The Voltage And Current.The Need Of Capacitor In Electrical Power System Has Many Advantages That Includes For Correcting Power Facto...

Behailu Gudeta, Shiva jaiswal
Vol 3, Issue 7 (July 2017) Electrical Engineering

Ameliorate the compensation of reactive power by using Static Synchronous Series Compensator

Power System Stability Problem Is An Occurrence Manifested As A Nonstandard Voltage, Current That Results In Disturbances Produced Which May Lead To Unwanted Or Unnecessary Effects On The Network, Such As Stability Disturbances, Voltage Flu...

Mr. Bhushan R. Aloni, Mr. Kalpesh M. Mahajan
Vol 3, Issue 7 (July 2017) Electrical Engineering

Improvement of Power Flow and Voltage Stability using Unified Power Flow Controller

In This Paper We Are Discussing About A FACTs Device Named As UPFC (unified Power Flow Controller). Its Special Features Are To Control Active And Reactive Power Course In A Transmission Line And To Adjust The Voltage At The Bus At Which It...

Vijay Kumar sharma , Gaurav Gangil
Vol 3, Issue 5 (May 2017) Electrical Engineering

Reactive Power Compensation using 12 MVA Capacitor Bank in 132/33 KV Distribution Substation

Shunt Capacitor Bank Improves The Power Factor, Increases Voltage Level On The Load And Reduces Current Flow Through The Transmission Lines. The Main Reason Of Installing A Capacitor Bank Is To Increase Power Factor Voltage Level. This Inap...

Yogesh U Sabale, Vishal U Mundavare, Pravin g Pisote, Mr. Vishal K Vaidya

Submit Your Paper to IJSART

Join the global research community with IJSART. Submit your paper, share your work, and gain worldwide recognition!