HOLDING AND WELDING FIXTURE FOR CASING WEAR RING |
Author(s): |
Mr. Shubham Asabe |
Keywords: |
Fixtures, Sai Industries |
Abstract |
During the machining process ring will become oval due to clamping forces. The existing problem for first step of product Casing Wear Ring is setup time too long. The differences between each technique were explained to decide the best method for setup time reduction. A high demand product was selected for setup improvement. The setup procedures were studied carefully and analyzed to identify underlying problems of current setup. After the new jig fabrication, an improved analysis was conducted again. Few suggestions were proposed to simplify or eliminate the bottleneck procedures. Time study of redesigned jig showed that the machine setup time was improved. Objectives of this research were achieved by redesigning the current jigs and fixtures. Three recommendations for future research are proposed in the last section of thesis. |
Other Details |
Paper ID: IJSARTV Published in: Volume : 7, Issue : 1 Publication Date: 1/4/2021 |
Article Preview |
Download Article |